Flat 3 Cremer Street Home User Guide

en Faults and what to do about them

Faults

Cause/Remedy

■ - - - - (Rinse stop = without final drain/spin) selected? ■ Clean the drain pump. ~ Page 41 ■ Clean outlet pipe and/or drainage hose.

Detergent solution is not drained.

Water not visible in the drum. Spin result not satisfac tory. Laundry wet/too damp. Spin cycle activated sev eral times. Residual water in the dis penser for care product. Compartment M is not rinsed out completely. Odour formation in the washer dryer. Status display Å is on. Foam may come out of the detergent drawer. Excessive noise, vibra tions and “wandering” during the spin cycle. Display panel/indicator lights do not function while the appliance is run ning. The programme duration changes during the wash cycle. Detergent residue on the laundry. Spin noise during the dry ing phase. Fluff found on the washed laundry.

Not a fault – water below the visible area.

■ Not a fault – unbalance detection system has stopped the spin cycle, washing unevenly distributed. Distribute small and large items of laundry in the drum. ■ Too low speed selected? Not a fault – unbalanced load detection system adjusts imbalance.

■ Not a fault – effect of the care product not impaired. ■ If required, remove the insert. Clean the detergent drawer and re-insert it.

Remove the insert. Clean the detergent drawer and reinsert it.

■ Run the Drum Clean 90°C programme without laundry and detergent. ■ Use appropriate detergent for daily washing. ■ keep the door and detergent dispenser open after using. Too much detergent used? ■ Mix 1 tablespoon of fabric softener with ½ litre of water and pour into dispenser II . (Not for outdoor, sports and down-filled textiles!) ■ Reduce detergent dosage for the next wash cycle. ■ Use commercially available low foam detergent and care products which are suitable for washer dryers. ■ Appliance feet fixed? Secure appliance feet. ■ Transportation bolts are removed? Removing the transportation bolts. ~ Page 13 ■ Appliance aligned? Align the appliance.

Power failure?

■ ■

Fuse tripped? Switch on/replace fuse.

■ If the fault occurs repeatedly, call customer service. ~ Page 46

■ Not a fault – unbalanced load detection system adjusts imbalance. ■ Not a fault – foam detection function active. Additional rinse cycle.

■ Occasionally phosphate-free detergents contain water-insoluble residue. ■ Select Rinse or brush items when the laundry is dry. This is an innovative process known as thermal spinning used to reduce energy consumption during the drying phase. Run the Drum Clean Ž (cold) programme without laundry and detergent to remove fluff which have accumulated inside the drum during the previous dry ing cycle.

44