17-48 Melfield Gardens

1. Installation and House Coding Disconnect the mains power supply. it is now safe to remove the Alarm from its mounting plate. Using a screwdriver, insert into the removal slot on the side of the Alarm (see Removing the Alarm section of the Alarm manual). Push the lower half of the Alarm away from the screwdriver, in the direction of the arrow on the cover ( see Fig. 1 ). CAUTION: The existing hard-wired interconnection may need to be disconnected at this point (refer to the Installation section in the Alarm instruction manual). If a hard-wired connection and an RF connection exist between the SAME two Alarms, a continuous Alarm loop signal may occur.

Figure 1

3